![]() This protocol has a quicker connect time than version 3, but lacks the version 3 feature set. If checked, Com Port Redirector always uses the version 2 protocol. ![]() If Timeout Reconnect is disabled, the connection attempt fails after this interval and no more attempts are made. If Timeout Reconnect is enabled, each connection attempt lasts this long. Specifies the maximum number of seconds that the Com Port Redirector waits for a connection to be made before giving up on this attempt. See your product reference manual for more information. To use this setting with SCSxx00 products, the server must run firmware V2.0/1 or higher and the word OR must be specified at the end of the server's connection (Define Port) string. To use this setting with MSS and ETS products, the server must run firmware V3.6/3 or higher and the word OR must be specified at the end of the server's connection (Define Port) string. This protocol allows settings like modem signals, baud rate and parity to be exchanged between Com Port Redirector and the server. If checked, Com Port Redirector uses the inband redirector protocol on inbound connections from a Lantronix server. If the port was closed by the communications application or by clicking Disconnect, Com Port Redirector does not try to auto-reconnect. When auto-reconnecting, Com Port Redirector tries to reconnect until the connection succeeds or you click the Cancel button in the pop-up connection dialog box. If checked, Com Port Redirector re-establishes the connection if the server closes it. ![]() If checked, Com Port Redirector re-establishes the connection if the connection times out (see the TCP Keepalive information in your device server user's guide). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |